Kenwood NX-5000 Series Common Function Reference page 386

17 STRUCTURING A MULTI RF DECK/ MULTI CONTROL HEAD
17.3 Replacing an RF Deck/ Control Head
6
Write the firmware.
To activate Multi RF Deck/ Multi Control Head, the firmware version 1.62.00 or later needs to be written.
The firmware version of a Control Head can be confirmed in Radio Mode Selection.
KFL
Figure 17-36 Triple RF Deck/ Dual Control Head (Firmware Setting)
Note
If "FPU MISMATCH" is displayed on the screen of the Control Head, proceed to step 7.
7
Write the FPU data.
The FPU data for Triple RF Deck/ Dual Control Head is written in a Multi RF Deck system. Always write the FPU
data in a Multi RF Deck system. Refer to
configuration data.
KPG-D1/ D1N
Note
If "FIRM MISMATCH" is displayed on the screen of the Control Head, start again from step 6.
Common FUNC (K, F)/Ver 2.20
Deck 1
RF
KRK-15B
Control Head
1
"Configuration in KPG-D1/ D1N If Control Heads Are
Deck 1
RF
KRK-15B
Control Head
1
Figure 17-37 Triple RF Deck/ Dual Control Head (FPU Setting)
RF Deck 2
KRK-15B
Switched" for writing
RF Deck 2
KRK-15B
CONTENTS INDEX
Deck 3
RF
KRK-15B
Control Head
2
Deck 3
RF
KRK-15B
Control Head
2
355