Resetting The Connection By Headset Profile - Kenwood NX-5000 Series Common Function Reference

10 BLUETOOTH COMMUNICATION
10.5 About Headset Profile (HSP Connection/ HSP Disconnection)
Configuration using KPG-D1/ D1N
0
Configuring Bluetooth Headset Connection Type (Control Head 2) (
> Optional Features 2 > GPS/Bluetooth > Bluetooth > Control Head 2)
0
Configuring Bluetooth Headset Connection Type (Portable) (
Optional Features 2 > GPS/Bluetooth > Bluetooth > Portable)
0
Configuring Bluetooth Headset Connection Type (RF Deck/Control Head 1) (
Features > Optional Features 2 > GPS/Bluetooth > Bluetooth > RF Deck/Control Head 1)

Resetting the Connection by Headset Profile

Connection by Headset Profile can be reset by one of the following methods:
0
Pressing the Bluetooth Connect / Disconnect key when a connected Bluetooth-compatible device exists
0 Placing the transceiver in Bluetooth My Devices Mode, selecting a connected Bluetooth-compatible device, and pressing
the Menu ([Q]) or [*] key (Refer to
0 Disabling Bluetooth
0
Moving outside the Bluetooth operation range
0
Receiving a disconnection request from a connected Bluetooth-compatible device
If connection by Headset Profile is reset by any of these methods, a Bluetooth Disconnect Tone (2 beeps) sounds from the
transceiver, the "V" icon blinks, and "Disconnected" appears on the display for 1 sec.
Also, connection by Headset Profile can be reset even by the following methods:
0
Turning the transceiver OFF
0
Disabling Bluetooth (Refer to
Common FUNC (K, F)/Ver 2.20
Displaying a Bluetooth-compatible Device (Bluetooth My
Z o n e 1
C h a n n e l 1
D i s c o n n e c t e d
Me nu Z on e+
Toggling Bluetooth On/ Off.)
Transceiver Settings > Optional Features
Transceiver Settings > Optional Features >
Transceiver Settings > Optional
12 : 34 A
M
CONTENTS
Devices).)
200
INDEX