Kenwood NX-5000 Series Common Function Reference page 365

16 MULTI RF DECK/ MULTI CONTROL HEAD
16.18 Relaying the Received Signal (Mobile Relay Station)
Exiting Mobile Relay Station Mode
Mobile Relay Station Mode can be exited by one of the following methods:
0
Pressing the Menu ([Q]) key
0 Deactivating the Mobile Relay Station port
0 Receiving a PC command from the communication port to disable Mobile Relay Station Mode
When Mobile Relay Station ends, the transceiver restarts in user mode. The Key Beep B (2 beeps) sounds from the
transceiver when the Menu ([Q]) key is pressed.
Note
When the Mobile Relay Station key is pressed, if the status of the Mobile Relay Station port is changed at the same time,
0
the transceiver behaves according to the status of the Mobile Relay Station port.
The status of Mobile Relay Station Mode is retained in the transceiver. Therefore, the transceiver starts in Mobile Relay
0
Station Mode when the transceiver is turned OFF in Mobile Relay Station Mode and the transceiver is turned ON again.
The receiving RF Deck can emit the received audio from the external speaker if the external speaker is connected to the
0
RF Deck. The received audio cannot sound from the speaker of the Control Head.
Encrypted audio can sound from the speaker. To do so, connect the SCM to RF Deck 1 and RF Deck 2.
0
In Mobile Relay Station Mode, the following functions of AUX Input/Output can be activated:
0
AUX Input:
Mobile Relay Station, Light Sense, Zeroize
AUX Output:
COR, TOR, TXS, LOK, Encryption
The following functions are unavailable in Mobile Relay Station Mode:
0
Built-in GPS Receiver/Bluetooth
0
Audio recording by the microSD function
0
OTAP
0
Bluetooth
0
Transmission and reception of a PC command by Bluetooth SPP
0
Reading and writing configuration data by using KPG-D1/ D1N
0
Emergency Mode
0
In a Triple RF Deck structure, the RF Deck not configured as an RF Deck for Mobile Relay Station does not behave as
0
the transceiver. However, the RF Deck can activate the AUX Input function only.
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF keys on the transceiver (
0
Assigning functions to the AUX Input port (
Common FUNC (K, F)/Ver 2.20
Transceiver Settings > Key Assignment)
Transceiver Settings > Extended Function > AUX)
CONTENTS INDEX
334