Kenwood NX-5000 Series Common Function Reference page 274

15 MODE
15.4 Changing the Configuration of the Transceiver (Front Panel Programming Mode)
15.4 Changing the Configuration of the Transceiver (Front Panel
Programming Mode)
This mode can be used to change data, such as the frequency on a Conventional Channel, and to add a Conventional
Channel in the transceiver only.
Even if no KPG-D1/ D1N and PC is available, required data can be configured by using only the transceiver.
Pressing the Front Panel Programming key places the transceiver in Front Panel Programming Mode. Or, pressing the
Menu key places the transceiver in Menu Mode, and the transceiver can be placed in Front Panel Programming Mode by
selecting "Panel Program". (Refer to
Note
To use this mode, a Radio Feature License (KWD-5001FP) is required.
Operating the transceiver
1
Press the Front Panel Programming
If Clone/Front Panel Programming Password is not configured:
The transceiver enters Front Panel Programming Mode.
If Clone/Front Panel Programming Password is configured:
The password entry display appears.
Press the Menu ([Q]) or [*] key after entering a password.
Refer to "Entering or Deleting a
If the correct password is entered, the transceiver enters Front Panel
Programming Mode.
2
Press the Menu ([
The zone selection display appears.
Common FUNC (K, F)/Ver 2.20
Using Menu Mode.)
key.
Code" for entry methods.
]) or [ ] key.
Panel Program
N ex t
Panel Program
Input Password
Panel Program
N ex t
Zone Select
Z o n e 2
Z o n e 6
Z o n e 7
N ex t
CONTENTS INDEX
12 : 34 A
M
12 : 34
A
M
12 : 34 A
M
12 : 34 A
M
2
243