About The Behavior In Function Mode While In A Dual Control Head Structure - Kenwood NX-5000 Series Common Function Reference

3 BASIC OPERATIONS
3.10 Operations in a Single RF Deck/ Dual Control Head Structure

About the Behavior in Function Mode While in a Dual Control Head Structure

The display and operation in Function Mode while in a Dual Control Head structure are as follows:
Display in Function Mode
0 A Control Head (operating side) operated to enter the mode by the operation such as of the PF keys displays the Function
Mode display of the appropriate function. If the operation of Control Head 1 (operating side) is enabled, "Head 1 in Use"
appears on the other Control Head 2 (non-operating side). If the operation of Control Head 2 (operating side) is enabled,
"Head 2 in Use" appears on the other Control Head 1 (non-operating side).
Also, because configuration change operations are unavailable in the non-operating Control Head, nothing appears in
Key Guide. Moreover, for the title display area, only the names of operating functions appear, and the list numbers do not
appear.
Control Head 1 (operating side)
0
In Menu Mode, the non-operating Control Head appears in the Function Mode Frame regardless of the configuration in
Menu Icon Size.
Control Head 1 (operating side)
Operation in Function Mode
0
The key operations are available for the operating Control Head according to the operation specifications of the mode.
0 Even if a specified key is pressed (such as the operation of the OK or Back key), a Key-entry Error Tone sounds from
the non-operating Control Head, and the non-operating Control Head does not respond at all because the configuration
operation cannot be done. Also, the function does not behave even if the function is assigned to this key.
0
The operation to exit the mode is available even for the non-operating Control Head. However, if the operating Function
Mode is Transceiver Password Mode, Front Panel Programming Mode, or Radio Mode Selection Mode, the mode cannot
be exited by the non-operating Control Head.
0
The operation of the PTT switch is available for the non-operating Control Head. Pressing the PTT switch ends Function
Mode and starts transmission. However, if the selected channel supports Selcall on PTT, transmission is executed
according to the configuration in Selcall on PTT.
0
The operation of the PTT switch is unavailable for the non-operating Control Head in the following Function Modes:
Transceiver Password Mode
0
Scan Program Mode
0
Front Panel Programming Mode
0
Radio Mode Selection Mode
0
0 A differing mode cannot be entered in each Control Head.
Common FUNC (K, F)/Ver 2.20
Control Head 2 (non-operating side)
Control Head 2 (non-operating side)
CONTENTS
74
INDEX