Configuring Mobile Relay Station - Kenwood NX-5000 Series Common Function Reference

16 MULTI RF DECK/ MULTI CONTROL HEAD
16.18 Relaying the Received Signal (Mobile Relay Station)

Configuring Mobile Relay Station

Preparation in advance
The configuration conditions of the Mobile Relay Station function are as follows:
Firmware version of the transceiver:
Firmware version 2.00.00 or later
FPU:
KPG-D1/ D1N V2.00 or later
Structure of transceivers:
Triple RF Deck or Dual RF Deck structure
Caution
Do not connect a D-sub 25-pin cable to the transceiver while the FPU data for Mobile Relay Station is not written
in the transceiver. A D-sub 25-pin cable may malfunction if the D-sub 25-pin cable is connected to the transceiver
in this state.
FPU configuration
Various functions of Mobile Relay Station are configured, and the configuration data is written to the transceiver by using
KPG-D1/ D1N.
1
Configure "Mobile Relay Station" to a
Note
When "Mobile Relay Station" is configured for the AUX Input port, configure for only RF Deck Data of 1 unit. If
"Mobile Relay Station" is configured for the AUX Input ports of RF Deck Data of 2 units, the behavior becomes
incorrect.
2
Configure the channel that behaves as a Mobile Relay Channel in
The channel for which the values in System Type, Channel Type, and Channel Spacing are the same as the other
channel needs to be configured as the Mobile Relay Channel. Also, configure both No.1 and No.2 RF Deck Data.
Note
Mobile Relay Station DB-25 Cable can be configured when No.1 and No.2 RF Deck Data are both configured.
0
In a Triple RF Deck structure, RF Deck Data of 2 random units can be selected and configured as Mobile Relay
0
Channels.
If a Mobile Relay Channel is not configured, the transceiver cannot enter Mobile Relay Station Mode.
0
Common FUNC (K, F)/Ver 2.20
PF key or AUX Input port.
Figure 16-83 Mobile Relay Channel List
Mobile Relay Channel List.
CONTENTS INDEX
325