Kenwood NX-5000 Series Common Function Reference page 149

6 SOUND
6.3 Tones that Sound When the Communication Starts/ Ends
6.3 Tones that Sound When the Communication Starts/ Ends
These tones sound when the communication starts or ends and notifies the user of it.
Using Sound to Notify the Timing to Start Communications (PTT Proceed Tone)
PTT Proceed Tone is the tone that sounds from the transceiver when the transceiver becomes available by a user pressing
the PTT switch.
In an LTR Trunking system, P25 Trunking system and NXDN Trunking system, a user needs to start speaking when the
repeater becomes available after pressing the PTT switch. Since this duration is not always the same, it is difficult for a user
to know when to start speaking after pressing the PTT switch. In this case, if a user starts speaking when a PTT Proceed
Tone (3 beeps) sounds from the transceiver, communication can be initiated without losing the beginning of a call.
In an Analog Conventional system, P25 Conventional system, NXDN Conventional system, and DMR Conventional system,
the PTT Proceed Tone is used to delay the start of a voice call by the transmitting transceiver when reception takes time,
such as when the receiving transceiver is scanning or when Battery Saver is used.
A PTT Proceed Tone (3 beeps) sounds from the transceiver when the length of time configured in Proceed Tone Delay
Time elapses after the transceiver starts transmission and enters the enabled state to modulate the audio signals.
Note
The transceiver does not transmit audio signals until the PTT Proceed Tone (3 beeps) stops sounding even if the
transceiver transmits upon pressing the PTT switch.
Configuration using KPG-D1/ D1N
0
Configuring PTT Proceed Tone (NXDN Trunking) to be enabled or disabled (
> Personal Features > NXDN Trunking > General)
0
Configuring PTT Proceed Tone (P25 Trunking) (Personality) to be enabled or disabled (
Personal > Personality > P25 Trunking)
0
Configuring PTT Proceed Tone (P25 Trunking) (Channel Table) to be enabled or disabled (
> Zone/Channel > Channel Edit > P25 Trunking)
0
Configuring PTT Proceed Tone (Conventional) to be enabled or disabled (
Features > Optional Features 2 > Conventional > PTT Proceed Tone)
0
Configuring PTT Proceed Tone (LTR Trunking) to be enabled or disabled (
Proceed Tone)
0
Configuring Proceed Tone Delay Time (
Conventional> PTT Proceed Tone)
Common FUNC (K, F)/Ver 2.20
Transceiver Settings> Optional Features> Optional Features 2 >
Transceiver Settings > Personal
Transceiver Settings >
Transceiver Settings
Transceiver Settings > Optional
Transceiver Settings > LTR > PTT
CONTENTS INDEX
118