3. Clearing the Unused Band Display
4. Automatic Power
Off (APO) —
You can clear the unused band from the display.
This transceiver also provides an Automatic Power off
Transmit and receive is not possible if you turn the
circuit. The circuit action is described below.
band display off.
(default is off.)
1. Press the F key for longer than one second.
1. To turn the APO function on/off, press the F key for
2. Press the BAND SEL key corresponding to the band
longer than 1 second and then press the MHz key .
to be cleared while the F indicator is flashing.
The APO indicator lights.
e— OFF-— appears on the specified band display for
10 seconds, and the specified band is no longer
displayed.
eWhen the power switch is turned on, — OF F— will
@) =
be displayed for 10 seconds, then disappears.
A 5 second audio confirmation tone will sound after 2
hours 59 minutes if no signal has been received and
if you have not performed any operation.
1 minute after this alert signal the transceiver will
To enable the band again, repeat steps 1 and 2.
shut itself off.
2. When the APO operates and the transceiver is shut
off, the transceiver can be reactivated by turning the
POWER switch back on.
49