Control Head Structure Is Operating - Kenwood NX-5000 Series Common Function Reference

17 STRUCTURING A MULTI RF DECK/ MULTI CONTROL HEAD
17.8 Changing Configuration Data of 1 RF Deck While a System in a Multi RF Deck/ Multi Control Head Structure Is Operating
17.8 Changing Configuration Data of 1 RF Deck While a System in
a Multi RF Deck/ Multi Control Head Structure Is Operating
The configuration data of an RF Deck can be changed while a system in a Multi RF Deck/ Multi Control Head structure is
operating. This section describes the procedure for changing the configuration data of RF Deck 2.
Note
The configuration data of RF Deck 1 and RF Deck 3 can be changed with the same procedure while a system in a Multi
0
RF Deck/ Multi Control Head structure is operating.
If even one piece of the configuration data is changed, the configuration data of all RF Decks and Control Heads needs
0
to be overwritten.
The configuration data of an RF Deck can be changed with the same procedure even if in a system of the following RF
0
Deck/ Control Head structures:
Triple RF Deck/ Single Control Head
0
Dual RF Deck/ Dual Control Head
0
Dual RF Deck/ Single Control Head
0
1
Edit the configuration data of RF Deck 2 by using KPG-D1/ D1N.
To create new configuration data of RF Deck 2, confirm that the following are configured in Product Information:
0
Multi RF Deck of Feature Selection is enabled.
0 The configuration of Control Head Configuration matches the actual system structure.
2
Turn ON all RF Decks and Dual Control Heads in a Triple RF Deck/ Dual Control Head structure.
Configuration data can be written to all RF Decks and Control Heads.
KPG-D1/ D1N
Common FUNC (K, F)/Ver 2.20
Deck 1
RF
KRK-15B
Control Head
1
Figure 17-64 Triple RF Deck/ Dual Control Head (FPU Setting)
RF Deck 2
KRK-15B
CONTENTS INDEX
Deck 3
RF
KRK-15B
Control Head
2
372