Kenwood NX-5000 Series Common Function Reference page 87

3 BASIC OPERATIONS
3.7 Viewing the Receive History (Stack)
Caller ID Stack
Caller ID Stack is the function to store IDs of callers in the stack memory.
The transceiver can store a maximum of 250 Caller IDs.
By selecting a Caller ID and pressing the PTT switch while in Stack Mode, the transceiver can respond to the Caller ID.
When the transceiver receives a call, the "
Mode, a user can check the stored IDs.
About the Caller ID Stack configuration
The transceiver behaves as follows according to the configuration in Caller ID Stack:
Configuration
None The Caller ID is not stored even if a call is received.
Individual Call Only the Caller ID of an Individual Call or Paging Call is stored.
The Caller IDs of all calls are stored. However, the Caller IDs of Unaddressed Calls and Broadcast Group
Any Call
Calls are not stored in a DMR Conventional system.
Note
The transceiver stores in combination a maximum of 250 Caller IDs and Status Messages in the stack memory. If no
0
Status Message is stored, the transceiver stores up to 250 Caller IDs.
The storage method varies depending on the configuration in Old Message Overwrite.
0
Configuration using KPG-D1/ D1N
0
Configuring Caller ID Stack (P25) to be enabled of disabled (
General > Stack)
0
Configuring Caller ID Stack (NXDN) (
0
Configuring Caller ID Stack (FleetSync) (
> Stack)
0
Configuring Caller ID Stack (MDC-1200) (
> Stack)
0
Configuring Caller ID Stack (DMR) (
Common FUNC (K, F)/Ver 2.20
" icon blinks to notify that the ID is being saved. If the transceiver enters Stack
Table 3-10 Caller ID Stack
Description
Transceiver Settings > NXDN > NXDN Information > General > Stack)
Transceiver Settings > FleetSync > FleetSync Information > General
Transceiver Settings > MDC-1200 > MDC-1200 Information > General
Transceiver Settings > DMR > DMR Information > General > Stack)
Transceiver Settings > P25 > P25 Information >
CONTENTS
56
INDEX