16 MULTI RF DECK/ MULTI CONTROL HEAD
16.4 Configuring the Initial Configuration
The following is the procedure to write the firmware if 3 RF Decks are used:
1
Make the system in a Single RF Deck/ Single Control Head structure.
Combination of Remote Kits varies depending on the type of Control Head.
Basic Panel (KCH-19)
Remote Kit for RF
Remote Kit for Head
2
Write the firmware of version 1.60.00 or later to each RF Deck with the Control Heads and RF Decks
connected.
The firmware is written to the Control Heads and RF Decks.
KRK-14H or KCH-20R
Common FUNC (K, F)/Ver 2.20
R F D eck
(N X-5*00)
KRK-15B
KCT-71
KRK-14H
Basic Panel
(KCH-19)
Figure 16-3 Single RF Deck/ Single Control Head
KRK-15B
RF Deck
Dip SW
(N X-5*00)
KRK-15B
KCT-71
Dip SW
KRK-14H
Basic Panel
(KCH-19)
Figure 16-4 Writing the Firmware
Featured Panel (KCH-20R)
Remote Kit for RF
KCT-71
RF Deck
RF Deck
(N X-5*00)
(N X-5*00)
KRK-15B
KRK-15B
KRK-14H
Featured
Basic Panel
(KCH-20R)
(KCH-19)
KFL
CONTENTS
R F D eck
(N X-5*00)
KRK-15B
Featured
Panel
(KCH-20R)
Panel
250
INDEX