Kenwood NX-5000 Series Common Function Reference page 267

13 TRANSCEIVER DATA PROTECTION WITH PASSWORD
13.3 Password for Writing Configuration Data (Overwrite Password)
13.3 Password for Writing Configuration Data (Overwrite
Password)
Overwrite Password is the function to protect the configuration data from being overwritten by unauthorized persons if the
transceiver should ever be stolen.
To write data using KPG-D1/ D1N to the transceiver with Overwrite Password configured, the password needs to be
entered on a PC.
Overwrite Password can be configured for the transceiver using KPG-D1/ D1N. Overwrite Password can be configured
using any numbers between 0 and 999999 inclusive.
Note
Copying data from another transceiver cannot occur by using the Clone function if Overwrite Password is configured
0
for the transceiver.
If the password authentication fails consecutively for the number of times configured in Password Entry Limit, the
0
transceiver enters Transceiver Lockout Mode, and then "LOCKOUT" appears on the display. In Transceiver Lockout
Mode, the transceiver cannot be operated. Writing configuration data to the transceiver by using KPG-D1/ D1N, the
transceiver exits Transceiver Lockout Mode.
Also, a failure in Read Authorization Password authentication counts as a failure in the password authentication. The
0
number of failures in the password authentication is cleared by one of the following conditions:
When the transceiver is turned OFF and then turned ON again
0
When the correct password is entered
0
When configuration data is written to the transceiver by using KPG-D1/ D1N
0
Configuration using KPG-D1/ D1N
0
Configuring Overwrite Password (
Password > Overwrite Password)
0
Configuring Password Entry Limit (
Password)
Common FUNC (K, F)/Ver 2.20
Transceiver Settings > Optional Features > Optional Features 1 > Data
Transceiver Settings > Optional Features > Optional Features 1 > Data
CONTENTS INDEX
236