Kenwood NX-5000 Series Common Function Reference page 275

15 MODE
15.4 Changing the Configuration of the Transceiver (Front Panel Programming Mode)
Note
Refer to the service manual for instructions on how to operate the transceiver in Front Panel Programming Mode.
0
0 To exit Front Panel Programming Mode, press the Home ([T]) key, and then press the Menu ([Q]) or [*] key on the
confirmation screen. The transceiver exits Front Panel Programming Mode and then restarts in User Mode.
Configuration using KPG-D1/ D1N
0
Configuring whether to permit the use of Front Panel Programming Mode (
Selection)
0
Configuring Clone/Front Panel Programming Password (
Features 1 > Password)
15.5 Overwriting the Firmware (Firmware Programming Mode)
Firmware Programming Mode can be used to write the firmware to the transceiver.
Operating the transceiver
1
Turn the transceiver ON while pressing and holding the
The transceiver enters Firmware Programming Mode.
Note
Refer to the service manual for instructions on how to operate the transceiver in Firmware Programming Mode, and on
0
how to write the firmware to the transceiver.
To end Firmware Programming Mode, the transceiver must be turned OFF.
0
If no firmware is written to the transceiver, the transceiver enters Firmware Programming Mode when the transceiver is
0
turned ON.
Configuration using KPG-D1/ D1N
Configuring whether to permit the use of Firmware Programming Mode (
> Optional Features 1 > Mode)
Common FUNC (K, F)/Ver 2.20
Model > Product Information > Feature
Transceiver Settings > Optional Features > Optional
AUX key.
Transceiver Settings > Optional Features
CONTENTS
F I R M W A R E P R O G
244
INDEX