Storing The Gps Data (Gps Data Storage) - Kenwood NX-5000 Series Common Function Reference

9 STORING RECORDED AUDIO/ GPS DATA

9.5 Storing the GPS Data (GPS Data Storage)

9.5 Storing the GPS Data (GPS Data Storage)
GPS Data Storage is the function to enable the GPS data to be stored in the internal memory and microSD card.
At the time intervals configured in GPS Storage Interval, the GPS data acquired from the GPS receiver unit is stored to
both in the internal memory and microSD card.
The acquired data is temporarily stored in the RAM in the transceiver, and if 3 data are stored, the data are collectively
stored in both the internal memory and microSD card. If 1 or 2 GPS data are temporarily stored in the RAM in the transceiver,
the GPS data are deleted without being stored in the internal memory and microSD card when the transceiver is turned
OFF.
A maximum of 7,000 GPS data can be stored in the internal memory. If the number of the GPS data reaches 7,000, the
older 3,500 GPS data are deleted, so the actual number of the GPS data which can be stored in the internal memory is
3,500.
In a microSD card, the GPS data of a maximum of 250 days or the GPS data with a size of the microSD card capacity can
be stored. The GPS data is stored according to the output format configured in GPS Data Record Format. If no output format
is configured, the GPS data is not stored.
The GPS data stored in the internal memory can be sent from the transceiver using wireless communication and be
transferred to a PC.
Caution
Do not disconnect the power source of the transceiver or remove the microSD card from the transceiver while the
GPS data is stored in the microSD card. Also, for Portable, be careful that the remaining battery power does not
run out. The data may not be stored, or the data may be damaged.
Sending and transferring the GPS data
0
Sending the GPS data using wireless communication
The transceiver sends the GPS stored in the internal memory to the base station according to the specified period and
specified number of data upon the receipt of a request message for the GPS data which is sent from the base station
using the NXDN air protocol.
Note
While the transceiver is sending the GPS data using wireless communication, new GPS data is not stored even if the
0
transceiver acquires the new GPS data from the GPS receiver unit.
If the number of the stored GPS data does not reach the number of data specified by the request message for the GPS
0
data which is sent from the base station, the transceiver sends all the stored GPS data to the base station.
0
Transferring the GPS data to a PC
To transfer the GPS data to a PC, the transceiver and the PC must be connected by a serial cable.
The transceiver transfers the GPS data stored in the internal memory to the PC according to the specified period and
specified number of data upon the receipt of a request message for the GPS data which is sent from the PC.
Note
To transfer the GPS data to the PC, the GPS data request message must be controlled using a PC application. Also,
0
Base Station Settings must be configured using KPG-D1/ D1N.
While the transceiver is transferring the GPS data using a PC command, new GPS data is not stored even if the transceiver
0
acquires the new GPS data from the GPS receiver unit.
If the number of the stored GPS data does not reach the number of data specified by the request message for the GPS
0
data which is sent from the PC, the transceiver sends all the stored GPS data to the PC.
If the configuration data with Audio/GPS Data Erase (Internal Memory) enabled is written, the GPS data stored in the
0
internal memory is deleted.
Common FUNC (K, F)/Ver 2.20
CONTENTS INDEX
172