Kenwood NX-5000 Series Common Function Reference page 273

15 MODE
15.3 Copying the Configuration Data to Another Transceiver (Clone Mode)
15.3 Copying the Configuration Data to Another Transceiver (Clone
Mode)
Clone Mode can be used to copy the data configured for the transceiver to another transceiver.
Operating the transceiver
1
Turn the transceiver ON while pressing and holding the
The transceiver enters Clone Mode.
Note
Refer to the service manual for instructions on how to operate the transceiver in Clone Mode, and for details on the Clone
0
function.
To end Clone Mode, the transceiver must be turned OFF.
0
The following data cannot be copied in Clone Mode:
0
Tuning Data
0
Embedded Message with Password
0
KENWOOD ESN Data
0
P25 ESN Data
0
NXDN ESN Data
0
If the data is copied to a transceiver having a different firmware version number, this may result in an error or a failure of
0
the transceiver to function correctly. In such a case, the cloned transceiver operation must be verified prior to using this
transceiver on a regular basis.
Clone Mode does not function in a Multi RF Deck system for Mobile.
0
Configuration using KPG-D1/ D1N
Configuring whether to permit the use of Clone Mode (
1 > Mode)
Common FUNC (K, F)/Ver 2.20
Function ([ ]) key.
Transceiver Settings > Optional Features > Optional Features
CONTENTS
C L O N E M O D E
Cl on e
242
INDEX