Kenwood NX-5000 Series Common Function Reference page 22

Outline of This Transceiver
ANALOG MODES
GENERAL
12.5 kHz (Narrow)/ 20.0 kHz (Wide 4k) (NX-5400/ NX-5900 only)/ 25.0 kHz (Wide) Channel Spacing
0
Conventional & LTR Systems
0
FleetSync/ FleetSync II, MDC-1200, DTMF
0
QT/ DQT/ 2-tone
0
Single Scan, List Scan
0
Priority Scan
0
Multi-Zone Scan
0
Voice Inversion Scrambler (16 Codes)
0
FleetSync
PTT ID/ Caller ID
0
Selective/ Group Call
0
*3
Status Message
0
Emergency, Short & Long Messages
0
AUX Input Status Message (Mobile Only)
0
AUX Output Status Message (Mobile Only)
0
Ignition On/ Off GPS Reporting (Mobile only)
0
MDC-1200
PTT ID/ Caller ID
0
Selective/ Group Call
0
Radio Check, Radio Inhibit/ Uninhibit
0
AUX Output ID (Mobile Only)
0
5-tone
Selective/ Group Call
0
Status Message
0
Emergency Call
0
*1 The maximum number of channels that can be configured for a transceiver in total is 1,024. With the Radio Feature
License (KWD-5000CH) enabled, the maximum number of configurable channels can be extended to 4,000. The
maximum number of Talkgroup IDs that can be configured in a P25 Trunking system is 512.
*2 The supported PC software and external devices need to be separately prepared for the transmitting transceiver.
To send messages or data with serial communications, the supported PC software and external devices need to be
*3
separately prepared for the transmitting transceiver. In addition, to send the received messages or data to external
devices, the supported PC software and external devices need to be separately prepared for the receiving transceiver.
*4 A sensor to detect the change of port status needs to be attached to the AUX Input port for the transmitting transceiver.
To remotely control external devices according to the change of port status, the external devises need to be connected
*5
to the AUX Output port for the receiving transceiver.
*6 These trunking functions rely on the programming and operation of the system. Priority Monitor also requires NX
subscriber settings.
For KPG-D1N, "Wide" cannot be configured in Channel Spacing if a receive frequency or a transmit frequency is
*7
configured in the following ranges:
VHF: above 149.98750 MHz and less than 174.01250 MHz
UHF: above 420.98750 MHz and less than 470.01250 MHz
Common FUNC (K, F)/Ver 2.20
*3
*4
*5
*5
*7
CONTENTS INDEX
xxi