External Ptt (Voice), External Ptt Data), And Data Ptt - Kenwood NX-5000 Series Common Function Reference

11 EXTERNAL PORTS
11.2 D-sub 25-pin Connector
Functions When Sending by Using the External PTT (Voice), External PTT (Data),
and Data PTT
The following functions that are used for sending by using the External PTT (Voice), External PTT (Data), and Data PTT
can be configured using KPG-D1/ D1N.
Configuration
Which modulation line is enabled can be configured for the External PTT (Voice) port, External
PTT (Data) port, and Data PTT port. The following modulation lines are available:
0
0
Modulation Line
0
However, the DI Line is enabled only when transmitting on an analog channel.
Whether to multiplex the QT tone or DQT code configured for an analog channel when transmitting
by using the Mic PTT, External PTT (Voice), External PTT (Data), and Data PTT ports can be
With QT/ DQT
configured. Normally, QT tone or DQT code is configured to be multiplexed.
This function functions only on an analog channel.
Whether to send the STE (Squelch Tail Eliminator) after sending the QT tone or DQT code
configured for an analog channel when transmitting by using the Mic PTT, External PTT (Voice),
External PTT (Data), and Data PTT ports can be configured. Normally, the transceiver is
configured to send the STE.
With STE
Sending the Squelch Tail Eliminator eliminates the noise that occurs in the receiving transceiver
when transmission ends.
This function functions only on an analog channel.
Configuration using KPG-D1/ D1N
Configuring functions used when sending by using External PTT (Voice), External PTT (Data), and Data PTT
( Transceiver Settings > Extended Function > Modulation Line)
Common FUNC (K, F)/Ver 2.20
Table 11-9 External PTT (Voice), External PTT (Data), Data PTT
Mic Line
Whether to enable the audio line of the microphone that is connected to the microphone
connector of the transceiver when transmitting by using the Mic PTT, External PTT (Voice),
External PTT (Data), and Data PTT ports can be configured.
MI2 Line
Whether to enable the audio modulation line of the D-sub 25-pin connector of the transceiver
when transmitting by using the Mic PTT, External PTT (Voice), External PTT (Data), and Data
PTT ports can be configured.
If the transceiver transmits by using the External PTT (Voice) port, the transceiver is often
configured to be modulated only by the MI2 Line.
DI Line
Whether to enable the data modulation line of the D-sub 25-pin connector of the transceiver
when transmitting by using the Mic PTT, External PTT (Voice), External PTT (Data), and Data
PTT ports can be configured.
If the transceiver transmits by using the External PTT (Data) or Data PTT port, the transceiver
is normally configured to be modulated only by the DI Line.
Operation
CONTENTS
223
INDEX