Kenwood NX-5000 Series Common Function Reference page 126

5 INDICATION AND DISPLAY
5.8 Automatically Adjusting the Brightness Level of the LCD (Auto Dimmer)
Note
This function can be used only if KCH-19 (Basic Panel) or KCH-20R (Featured Panel) is used.
0
In a Dual Control Head structure, the changed configuration is applied to the Control Head for which the configuration of
0
Auto Dimmer is changed. Also, Auto Dimmer can be configured for each Control Head by using KPG-D1/ D1N. The
configuration in Auto Dimmer applies to Control Head 1, and the configuration in Auto Dimmer for Control Head 2
applies to Control Head 2.
Auto Dimmer is automatically disabled while the transceiver is in the following modes. After exiting the modes, Auto
0
Dimmer behaves according to the configuration. When in Firmware Programming Mode, the transceiver behaves at the
brightness level of High in LCD Brightness for Portable, and the transceiver behaves at the brightness level of Level 7
in LCD Brightness for Mobile. When in other modes, the transceiver behaves at the brightness level configured in LCD
Brightness.
Test Mode
0
Clone Mode
0
Firmware Programming Mode
0
Transceiver Information Mode
0
FPU Programming Mode
0
Stun/Kill
0
Radio Inhibit
0
Emergency Mode (Emergency Mode Type = Silent)
0
Key Loader Mode
0
Radio Authentication Key Loader Mode
0
Configuration using KPG-D1/ D1N
0
Configuring Auto Dimmer (
0
Configuring Auto Dimmer for Control Head 2 (
1 > Display)
Common FUNC (K, F)/Ver 2.20
Transceiver Settings > Optional Features > Optional Features 1 > Display)
Transceiver Settings > Optional Features > Optional Features
CONTENTS INDEX
95