Kenwood NX-5000 Series Common Function Reference page 372

17 STRUCTURING A MULTI RF DECK/ MULTI CONTROL HEAD
17.1 Initial Configuration for Multi RF Deck/ Multi Control Head
2
Write the firmware.
The firmware is written after the programming cable is connected to Control Head 1.
1. Start up KFL to open the firmware (Ver.1.62.00 or later) of the NX-5000 series.
Configure COM Port, and configure "Auto" in Baud Rate.
2. Connect the transceiver to the PC by using KPG-46UM or KPG-46XM.
3. Click the "Write" button of KFL.
If the writing is successful, a message box appears.
4. Click the "OK" button.
5. Confirm the checksum of the firmware on the transceiver display.
Confirm that the appropriate firmware is written. If the checksum is incorrect, reexecute the operations from step
1 (Connect the RF Deck to the Control Head by using the KCT-71 cable, and turn the transceiver ON.).
6. Restart the transceiver.
Common FUNC (K, F)/Ver 2.20
Figure 17-9 KFL
Figure 17-10 Message Box
CONTENTS INDEX
341