Kenwood NX-5000 Series Common Function Reference page 426

19 CONFIGURATION FOR EACH FUNCTION
19.1 Available Functions for the PF Keys
Function Name
A Call Interruption request message is sent.
See
Call Interruption
DMR FUNC
the Transmitting Transceiver (Call Interruption)
Pressing the Call Response key when receiving an Individual Call causes the
transceiver to respond.
See
P25 FUNC
0
Call Response
NXDN FUNC
0
Party Is Available for Communications (Individual Call Acknowledge
Request)
NXDN FUNC
0
Party Is Available for Communications (Message Trunked (Enhanced))
Channel Down Decreases the channel number in steps of 1.
Pressing and holding the Channel Down key causes the channel number to
be decreased in steps of 1 every 200 ms.
Channel Down
Note
(Continuous)
Channel Down (Continuous) can be configured only in Hold for the Channel
Down key, and the configuration cannot be changed.
Directly specify the channel number by pressing a key(s) on the keypad.
Channel Entry See
Changing the Channel by Specifying the Number (Channel Entry)
Channel Changes the display of the transceiver in order of the channel name, Zone-
Information channel number, frequency, QT/ DQT, and RAN code.
Pressing the Channel Recall key while scanning causes Channel Recall to
be toggled between enabled and disabled. If Channel Recall is enabled, the
transceiver migrates to the channel on which a signal was last received.
See
Channel Recall
NXDN FUNC
0
P25 FUNC
0
DMR FUNC
0
Channel Up Increases the channel number in steps of 1.
Pressing and holding the Channel Up key causes the channel number to be
increased in steps of 1 every 200 ms.
Channel Up
Note
(Continuous)
Channel Down (Continuous) can be configured only in Hold for the Channel
Up key, and the configuration cannot be changed.
Aborts the current mode, disconnects communication, or cancels data
Clear
transmission.
The current time appears.
Clock See
Displaying the Current Time
The current time can be adjusted.
Clock Adjustment See
Adjusting the Time
Sends the CW Message configured for the transceiver.
CW Message See
NXDN FUNC
Common FUNC (K, F)/Ver 2.20
Description
Terminating Voice Communications by a Transceiver Other Than
Making an Individual Call
Initiating an Individual Call After Ensuring That the Target
Initiating an Individual Call After Ensuring That the Target
SCAN
### Error: NO TOC title. ###
SCAN
Communicating using a CW Message
Available
Communication
Systems
DMR Conventional
P25 Trunking
NXDN Conventional
NXDN Trunking
ALL
ALL
ALL
ALL
ALL
ALL
ALL
P25 Trunking
NXDN Conventional
NXDN Trunking
DMR Conventional
ALL
ALL
NXDN Conventional
CONTENTS INDEX
*1
395