Table of Contents
Advertisement
Then choose from the following:
How to Save and Recall Limits
In addition to saving and recalling limits with an *.sta file, limit lines can also be
saved and then recalled independent of the current mode or measurement. Use
this feature to recall and apply existing limit lines to measurements with
different settings or even a different frequency range.
Limit line files can be loaded into the FieldFox Data Link Software. Learn how in
the help file that is included in the Data Link software.
How to Save and Recall Limits
Press Save/Recall then
Then press Limit .
Then choose from the following:
All about Trace Math
Trace Math is available ONLY in CAT and NA Modes, but not in DTF
measurements.
A trace is a series of measurement data points that are connected to form a line.
This 'live' data trace is updated as data points are measured.
Data Analysis Features
Beep
o
On Pass
o
Audible beep sounds when a sweep passes.
On Fail
o
Audible beep sounds when a sweep fails.
Off
o
No audible beep sounds.
Warning On Off
Shows
o
sweep. Data points that fail are highlighted.
Limit Type
o
Offset
Shifts the limit line up or down. Enter an offset value using the rotary
o
knob, the ▲|▼ arrows, or by entering a value with the number keys.
o
Enter a positive offset to shift the limit line UP, usually used with UPPER
limits.
o
Enter a negative offset to shift the limit line DOWN, usually used with
LOWER limits.
Margin
Shifts the limit line up or down like an offset, but only virtually. The
o
limit line does NOT appear to move. Enter a Margin value using the rotary
knob, the ▲|▼ arrows, or by entering a value with the number keys.
o
Enter a positive margin to virtually shift the limit line UP.
o
Enter a negative margin to virtually shift the limit line DOWN.
USB flash drive) to be used for the Save or Recall. Learn more on page 166.
Save Limits
After limit lines have been defined, this saves the line
o
definition to a file on the specified device.
Recall Limits
Recalls a limit Line definition from the specified device.
o
Pass
or
Fail
indication on the display with each
Select Device
to set the Device (Internal, SD card, or
161
Advertisement
Chapters
Table of Contents
