2
Operation and Features
Source voltage operation
To set up the U2722A/U2723A for source voltage operation, proceed as
follows.
Agilent Measurement Manager operation
1 Connect a load to the output terminals.
2 Turn on the U2722A/U2723A.
Figure 2-2 Panel view of the Agilent Measurement Manager
32
Turn off the U2722A/U2723A power. Connect a load to the OUTPUT+
and OUTPUT– terminals of an output channel.
The U2722A/U2723A will go into a power-on or reset state; the output
is disabled. Ensure that the USB interface has already been connected
between the U2722A/U2723A and PC. Run the Agilent Measurement
Manager software to control the U2722A/U2723A remotely.
On the application panel as shown in
that you have connected. Select the required voltage and current ranges.
Otherwise, enable Auto Range for both voltage and current. Proceed to
select Source Voltage.
Figure 2-
2, select the channel
U2722A/U2723A User's Guide