Removing The Defective Expansion Card; Installing The New Expansion Card; Connecting Cables To The Expansion Card; Connecting A Battery Backup Unit To The Expansion Card - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

Expansion cards and backup units
"Getting access to the component" on page 68
Ê
Ê If applicable, disconnect internal cables from the expansion card.
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section
page 584.
8.5.5.2

Removing the defective expansion card

Ê If applicable, remove the riser module 1 as described in section
the riser module 1 (HL)" on page
Ê If applicable, remove the riser module 2 as described in section
the riser module 2 (HL)" on page
Ê Remove the expansion card as described in section
expansion card from a riser module" on page
8.5.5.3

Installing the new expansion card

Ê Install the new expansion card as described in section
expansion card in a riser module" on page
Ê If applicable, install the new expansion card as described in section
"Installing a PCIe expansion card in a riser module" on page
Ê If applicable, install the riser module 1 as described in section
expansion card in riser module 1" on page
Ê If applicable, install the riser module 2 as described in section
riser module 2 (HL)" on page
8.5.5.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
cables" on page
8.5.5.5

Connecting a battery backup unit to the expansion card

Ê If applicable, connect an FBU cable to the expansion card as described in
section "Connecting the FBU to the RAID controller" on page
278
"Onboard indicators and controls" on
84.
87.
88.
559.
Upgrade and Maintenance Manual
"Removing a PCIe
270.
"Installing a PCIe
266.
263.
"Removing
"Removing
266.
"Installing an
"Installing the
"List of used
318.
RX2540 M2