Removing The Defective Expansion Card; Installing The New Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX2530 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
"Disconnecting the server from the mains" on page 49
Ê
"Getting access to the component" on page 49
Ê
"Locating the defective component" on page 47
Ê
Ê Remove the corresponding riser module as described in section
riser modules" on page
9.5.3.2

Removing the defective expansion card

Ê Remove the expansion card as described in section
expansion card" on page
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card as described in section
on page 172.
9.5.3.3

Installing the new expansion card

Ê If applicable, install the slot bracket as described in section
bracket" on page
Ê Install the expansion card as described in section
card" on page
9.5.3.4

Concluding steps

Ê Install the corresponding riser module as described in section
riser modules" on page
"Reassembling" on page 54
Ê
"Connecting the server to the mains" on page 60
Ê
"Enabling replaced components in the system BIOS" on page 90
Ê
"Updating RAID controller firmware" on page 82
Ê
"Enabling SVOM boot watchdog functionality" on page 89
Ê
"Switching on the server" on page 61
Ê
"Resuming BitLocker functionality" on page 95
Ê
Ê After replacing a network controller in a server running Linux OS,
the NIC configuration file in a Linux environment" on page
196
62.
194.
170.
191.
62.
Upgrade and Maintenance Manual
"Handling
"Removing the
"Removing a slot bracket"
"Installing a slot
"Installing the expansion
"Handling
"Updating
93.
RX2530 M1