Installing The New Expansion Card; Concluding Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Ê If applicable, "Removing an SFP+ transceiver module" on page
Ê If the slot bracket on the defective expansion card is to be reused:
"Removing a slot bracket" on page
9.4.3.3

Installing the new expansion card

Ê If applicable, "Installing a slot bracket" on page
Ê If applicable, "Installing the SFP+ transceiver modules" on page
Ê Install the expansion card, see section
page 281.
9.4.3.4

Concluding steps

Ê If applicable, install the SAS expander holder, see section
SAS expander holder" on page 254
Ê Install the system fan module, see section
on page 83.
"Reassembling" on page 67
Ê
Ê Connect all external cables to the replaced expansion card.
"Connecting the power cord" on page 78
Ê
"Switching on the server" on page 80
Ê
"Enabling replaced components in the BIOS" on page 112
Ê
Ê Inform the customer about changed WWN, MAC and SAS addresses, see
section "Looking for MAC/WWN/GUID and SAS addresses" on page
"Updating the NIC configuration file in a Linux and VMware environment" on
Ê
page 116
"Updating expansion card firmware" on page 104
Ê
"Resuming BitLocker functionality" on page 117
Ê
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For more information, see section
settings recovery" on page
TX1330 M4
272.
288.
Upgrade and Maintenance Manual
Expansion cards and backup units
271.
"Installing an expansion card" on
"Installing the system fan module"
"Note on network
276.
273.
"Installing the
118.
289