Expansion cards and backup units
9.5.3.1
Preliminary steps
"Locating the defective server" on page 47
Ê
Ê If applicable,
"Configuring LAN teaming" on page 105
"Suspending BitLocker functionality" on page 77
Ê
"Shutting down the server" on page 49
Ê
"Disconnecting the power cord" on page 50
Ê
"Getting access to the component" on page 52
Ê
"Locating the defective component" on page 48
Ê
Ê Remove the corresponding riser module, see section
modules" on page
9.5.3.2
Removing the defective expansion card
Ê Remove the expansion card, see section
page
231.
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see section
page
205.
9.5.3.3
Installing the new expansion card
Ê If applicable, install the slot bracket, see section
page
204.
Ê Install the expansion card, see section
page
222.
9.5.3.4
Concluding steps
Ê Install the corresponding riser module, see section
on page
67.
"Reassembling" on page 57
Ê
Ê If applicable, connect external cables to the expansion card.
"Connecting the power cord" on page 63
Ê
"Switching on the server" on page 66
Ê
234
67.
Upgrade and Maintenance Manual
"Handling riser
"Removing the expansion card" on
"Removing a slot bracket" on
"Installing a slot bracket" on
"Installing the expansion card" on
"Handling riser modules"
RX2530 M4