Installing A New Expansion Card - Fujitsu Primergy RX200 S4 Operating Manual

Replacement of non-hot-plug components
8.2.3.4

Installing a new expansion card

Figure 40: The riser module fully assembled
Ê Carefully press the new expansion card into the riser card slot, until it clicks
into place.
Make sure that the lug on the slot cover clicks into place in the corresponding
hole.
Ê If necessary, secure the expansion card with two screws (a).
Ê If necessary, connect the cables to the expansion card.
110 Operating manual
CSS components
a a
RX200 S4