Installing The New Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX200 S8 Upgrade And Maintenance Manual

9.4.5.3

Installing the new expansion card

Ê Install the expansion card as described in section
card - slot 1-3" on page 154
page 157.
9.4.5.4

Concluding steps

Ê Install the corresponding riser module as described in section
riser modules" on page
"Reassembling" on page 52
Ê
"Connecting the server to the mains" on page 57
Ê
"Enabling replaced components in the system BIOS" on page 79
Ê
"Updating RAID controller firmware" on page 73
Ê
"Enabling SVOM boot watchdog functionality" on page 78
Ê
"Switching on the server" on page 58
Ê
"Enabling BitLocker functionality" on page 83
Ê
Ê After replacing a network controller in a server running Linux OS,
the NIC configuration file in a Linux environment" on page
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For further information, please refer to section
network settings recovery" on page 164
Ê If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
Ê Inform the customer about changed WWN and MAC addresses, see
"Looking up changed MAC / WWN addresses" on page
RX200 S8
or "Installing the expansion card - slot 4" on
58.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the expansion
88.
"Handling
"Updating
82.
"Note on
"After replacing /
85.
165