Installing The New Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX1330 M1 Upgrade And Maintenance Manual

Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card as described in section
on page 163.
9.4.3.3

Installing the new expansion card

Ê If applicable, install the slot bracket as described in section
bracket" on page
Ê Install the expansion card as described in section
card" on page
9.4.3.4

Concluding steps

Ê Install the corresponding riser module as described in section
riser modules" on page
"Reassembling" on page 52
Ê
"Connecting the server to the mains" on page 55
Ê
"Enabling replaced components in the system BIOS" on page 79
Ê
"Updating RAID controller firmware" on page 74
Ê
"Enabling SVOM boot watchdog functionality" on page 78
Ê
"Switching on the server" on page 57
Ê
"Resuming BitLocker functionality" on page 84
Ê
Ê After replacing a network controller in a server running Linux OS,
the NIC configuration file in a Linux environment" on page
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For further information, please refer to section
network settings recovery" on page
Ê If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
Ê Inform the customer about changed WWN and MAC addresses, see
"Looking up changed MAC / WWN addresses" on page
RX1330 M1
161.
171.
58.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Removing a slot bracket"
"Installing the expansion
174.
88.
"Installing a slot
"Handling
"Updating
83.
"Note on
"After replacing /
85.
175