Replacing The 16X 2.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX4770 M5 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state disk (SSD)
Removing the defective 2.5-inch HDD/SSD module
▶ Remove the HDD/SSD module, see
module" on page
▶ If applicable, remove the HDD/SSD from the installation frame, see
"Handling HDDs or SSDs without installation frame" on page
Installing the new 2.5-inch HDD module
▶ If applicable, install the HDD/SSD in the installation frame, see
HDDs or SSDs without installation frame" on page
▶ Install the HDD/SSD module, see
on page 149.
Concluding steps
▶ If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see
array rebuild" on page
7.4.5

Replacing the 16x 2.5-inch HDD backplane

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove the air duct from the top system board, see
air duct" on page
154
150.
"Installing a 2.5-inch HDD/SSD module"
109.
72.
Upgrade and Maintenance Manual
"Removing a 2.5-inch HDD/SSD
140.
Hardware: 20 minutes
43.
45.
46.
47.
"Removing the CPU
140.
"Handling
"Performing a RAID
RX4770 M5