Removing the defective 3.5-inch HDD module
▶ Remove the HDD module, see
page
130.
▶ If applicable, remove the HDD from the installation frame, see
HDDs or SSDs without installation frame" on page
Installing the new 3.5-inch HDD module
▶ If applicable, install the HDD in the installation frame, see
or SSDs without installation frame" on page
▶ Install the HDD module, see
page
128.
Concluding steps
▶ If applicable,
"Installing the front cover with lock" on page
▶ If the HDD is configured using a RAID controller with a RAID level higher
than "0", the rebuild will start automatically, see
rebuild" on page
7.4.5
Replacing the 4x 3.5-inch HDD backplane
Field Replaceable Unit
(FRU)
Tools:
tool-less
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
RX1330 M5
Hard disk drive (HDD) / solid state disk (SSD)
"Removing a 3.5-inch HDD module" on
"Installing a 3.5-inch HDD module" on
87.
Upgrade and Maintenance Manual
121.
121.
"Performing a RAID array
Hardware: 10 minutes
43.
46.
47.
49.
"Handling
"Handling HDDs
61.
45.
133