▶ Insert all HDD/SSD modules, see
page
152.
Ensure that you install the HDD module in the bay it was located
before the HDD backplane replacement.
▶ Insert all dummy modules, see
page
155.
▶
"Installing the fan cage" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ Verify that the iRMC S6 recognizes the installed HDDs/SSDs.
▶ If applicable,
"Installing the front cover with lock" on page
7.5.6
Replacing the 12x 3.5-inch HDD backplane
Field Replaceable Unit
(FRU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Removing the fan cage" on page
RX2540 M7
Hard disk drive (HDD) / solid state disk (SSD)
"Installing a 3.5-inch HDD module" on
"Installing a 3.5-inch dummy module" on
77.
59.
65.
71.
50.
76.
Upgrade and Maintenance Manual
Hardware: 15 minutes
47.
50.
55.
71.
49.
161