Replacing The 12X 3.5-Inch Hdd Backplane; Preliminary Steps - Fujitsu PRIMERGY RX2520 M4 Upgrade And Maintenance Manual

Hard disk drive (HDD) and solid state drive (SSD)
7.4.9

Replacing the 12x 3.5-inch HDD backplane

Field Replaceable Unit
(FRU)
Tools: Phillips PZ2 / (+) No. 2 screw driver / hexagon screw driver 5 mm
7.4.9.1

Preliminary steps

"Locating the defective server" on page 45
Ê
"Suspending BitLocker functionality" on page 67
Ê
"Shutting down the server" on page 48
Ê
"Disconnecting the power cord" on page 49
Ê
Ê Release all HDD modules and pull them out a few centimeters, see section
"Replacing a 3.5-inch HDD module" on page
V
CAUTION!
The HDD modules need not to be removed completely. But if you
want to remove them nevertheless, make sure that all HDD/SSD
modules can be installed again into their original bay. Otherwise, data
may be lost.
"Getting access to the component" on page 50
Ê
"Removing the air duct" on page 61
Ê
"Removing the fan holder" on page 63
Ê
176 Upgrade and Maintenance Manual
Hardware: 15 minutes
167.
RX2520 M4