Edge-Core ECS4660-28F Management Manual page 565

Hide thumbs Also See for ECS4660-28F:

Table of Contents

Figure 308: Configuring Detailed Settings for Maintenance Associations

Use the Administration > CFM (Configure MEP – Add) page to configure

Maintenance End Points (MEPs). MEPs, also called Domain Service Access

Points (DSAPs), must be configured at the domain boundary to provide

management access for each maintenance association.

"CFM Commands" on page 1561

CFM elements must be configured in the following order: (1)

maintenance domain at the same level as the MEP to be configured

association within the domain (see

Associations"), and (3) finally the MEPs using the MEP List.

An interface may belong to more than one domain, or to different MAs

in different domains.

To change the MEP's MA or the direction it faces, first delete the MEP,

and then create a new one.

These parameters are displayed:

MD Index – Domain index. (Range: 1-65535)

MA Index – MA identifier. (Range: 1-2147483647)

MEP ID – Maintenance end point identifier. (Range: 1-8191)

MEP Direction – Up indicates that the MEP faces inward toward the

switch cross-connect matrix, and transmits CFM messages towards,

"Configuring CFM Maintenance

| Basic Administration Protocols

Connectivity Fault Management

Domains"), (2) maintenance

"Configuring CFM Maintenance

Chapters

Table of Contents