Parameters Available In The Setup Group - YASKAWA V1000 Series Installation & Start-Up Manual

◆

Parameters Available in the Setup Group

Table 4.4 lists parameters available in the Setup Group. This manual also explains
other parameters that are not visible in the Setup Group. The "Par" menu in the
Programming mode must be used to access other parameters not listed in the Setup
Group. The Setup Group parameters are shown in
Parameter
A1-02 Control Method Selection
A1-06 Preset Application Selection
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
b1-03 Stop Method Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-01 Duty Selection
C6-02 Carrier Frequency Selection
d1-01 Frequency Reference 1
d1-02 Frequency Reference 2
d1-03 Frequency Reference 3
d1-04 Frequency Reference 4
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
Table 4.4 Setup Group Parameters
Name Parameter
4.2 Using the Digital LED Operator
Table 4.4.
d1-17 Jog Frequency Reference
E1-01 Input Voltage Reference
E1-04 Maximum Output Frequency (FMAX)
E1-05 Maximum Voltage (VMAX)
E1-06 Base Frequency (FA)
E1-09 Minimum Output Frequency (FMIN)
E1-13 Base Voltage (VBASE)
E2-01 Motor Rated Current
E2-11 Motor Rate Capacity
E3-13 Motor 2 Base Voltage (VBASE)
H4-02 Terminal FM Gain Setting
L1-01 Motor Protection Function Selection
L3-04 Stall Prevention Selection during Deceleration
Name
117
4