Subaru Impreza 2003 Service Manual page 2679

7) Install the ST on rack and equally apply a thin
coat of grease to the rack and ST, then install the oil
seal.
ST 926250000 GUIDE
CAUTION:
Be careful not to scratch the oil seal lips with
piston's inner ring section.
(1) Rack piston inner ring
(2) Outer side oil seal
(3) Rack
8) Apply a coat of grease to the grooves in rack,
sliding surface of sleeve and sealing surface of pis-
ton. Install the ST on end of steering body cylinder.
Then insert the rack into steering body from cylin-
der side.
ST 34199AE000 GUIDE (Oil seal)
CAUTION:
Do not allow grease to block the air vent hole on
rack.
(1) Cylinder side of steering body
(2) Air vent hole
(3) Oil seal
(4) Rack
STEERING GEARBOX [RHD MODEL]
PS-00078
PS-00079
PS-55
POWER ASSISTED SYSTEM (POWER STEERING)
9) Make the ST2 pass through rack, and then push
in the rack and ST2 using a press until ST1 comes
in contact with ST2 and the end of rack is aligned
with end of ST2.
ST1 34199AE000 GUIDE (Oil seal)
ST2 34199AE010 INSTALLER (Oil seal)
ST1
(1) Outer side oil seal
(2) Rack piston
(3) Inner side oil seal
10) Install a new holder to cylinder side of steering
body.
Tightening torque:
64 N·m (6.5 kgf-m, 47.0 ft-lb)
ST2
(1)
(2)
(3)
PS-00431
PS-00063