Subaru Impreza 2003 Service Manual page 2692

POWER ASSISTED SYSTEM (POWER STEERING)
6) Tighten the joint nut.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
7) Connect the pipes A and B to four pipe joints of
gearbox. Connect the upper pipe B first, and lower
pipe A second.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
(2)
(1)
(1) Pipe A
(2) Pipe B
(1) High pressure hose
PIPE ASSEMBLY [LHD MODEL]
PS-00026
(B)
(A)
(2) No interference is allowed
between hoses.
PS-68
8) Install the jack-up plate.
9) Install the air intake duct. <Ref. to IN(H4SO)-6,
INSTALLATION, Air Intake Duct.>
10) Install the air intake duct, air cleaner upper cov-
er and air intake boot.
<Ref. to IN(H4DOTC)-7, INSTALLATION, Air
Cleaner.> and <Ref. to IN(H4SO)-6, INSTALLA-
TION, Air Intake Duct.>
11) Connect the battery ground cable to battery.
12) Feed the specified fluid.
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
13) Finally check clearance between pipes and/or
hoses, as shown above.
If cruise control actuator-to-power steering hose
clearance is less than 10 mm (0.39 in), move the
portion (A) secured by clamp to other portion, or
bend portion (B) to adjust.
(1)
(2)
(3)
(3) Clearance between crossmember
and pipe: 3 — 8 mm (0.12 — 0.31 in)
PS-00179