Subaru Impreza 2003 Service Manual page 2665

21) Apply a coat of grease to the sliding surface of
sleeve and seating surface of spring, and then in-
sert sleeve into steering body.
Charge the adjusting screw with grease, and then
insert the spring into adjusting screw and install on
steering body.
(1)
(1) Sleeve
(2) Spring
(3) Adjusting screw
22) Tighten the adjusting screw to specified torque.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
23) After tightening to the specified tightening
torque, loosen it by 25°.
24) Verify that play is within specified value. <Ref.
to PS-43, SERVICE LIMIT, INSPECTION, Steering
Gearbox [LHD MODEL].>
25) Loosen the adjusting screw, and then apply liq-
uid gasket to at least 1/3 of the entire perimeter of
adjusting screw thread.
Liquid gasket:
THREE BOND 1141
(1) Apply liquid gasket to at least 1/3 of entire
perimeter.
26) Tighten the adjusting screw to specified torque.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
27) After tightening to the specified tightening
torque, loosen it by 25°.
STEERING GEARBOX [LHD MODEL]
(3)
(2)
PS-00167
PS-00092
PS-41
POWER ASSISTED SYSTEM (POWER STEERING)
28) Install the lock nut. While holding the adjusting
screw with a wrench, tighten lock nut using ST.
ST 926230000 SPANNER
Tightening torque (Lock nut):
39 N·m (4.0 kgf-m, 28.9 ft-lb)
NOTE:
Hold the adjusting screw with a wrench to prevent it
from turning while tightening lock nut.
29) Remove the gearbox from ST.
30) Install the four pipes on gearbox.
(1) Connect the pipe A and B to the gearbox.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
(2) Connect the pipe E and F to gearbox.
Tightening torque:
Pipe E: 15 N·m (1.5 kgf-m, 10.8 ft-lb)
Pipe F: 25 N·m (2.5 kgf-m, 18.1 ft-lb)