Subaru Impreza 2003 Service Manual page 2561

3. Front Disc Rotor
A: REMOVAL
1. 14 INCH AND 15 INCH TYPE
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift-up the vehicle, and then remove the front
wheel.
4) Remove the caliper body and support from
housing, and suspend it from strut using a wire.
5) Remove the disc rotor.
NOTE:
If the disc rotor seizes up within the hub, drive the
disc rotor out by installing an 8-mm bolt in holes (B)
on rotor.
A
6) Clean mud and foreign particles from the caliper
body assembly and support.
FRONT DISC ROTOR
2. 16 INCH AND 17 INCH TYPE
1) Set the vehicle on a lift.
2) Loosen the wheel nut.
3) Lift-up the vehicle, and then remove the front
wheel.
4) Remove the caliper body from housing and sus-
pend from strut using a wire.
5) Remove the disc rotor from hub.
NOTE:
BR-00017
If the disc rotor seizes up within the hub, drive the
disc rotor out by installing an 8-mm bolt in holes B
on rotor.
B
6) Clean mud and foreign particles from the caliper
body assembly and support.
BR-00018
B: INSTALLATION
1) Install the disc rotor.
2) Install the caliper body and support to housing.
Tightening torque:
3) Install the wheel.
BR-29
A
Except 17 inch type:
80 N·m (8.2 kgf-m, 59 ft-lb)
17 inch type:
155 N·m (15.8 kgf-m, 114.3 ft-lb)
BRAKE
BR-00297
B
BR-00018