Subaru Impreza 2003 Service Manual page 2673

21) After adjusting the toe-in and steering angle,
tighten the lock nut on tie-rod end.
Tightening torque:
83 N·m (8.5 kgf-m, 61.5 ft-lb)
NOTE:
When adjusting the toe-in, hold boot as shown to
prevent it from being rotated or twisted. If twisted,
straighten it.
C: DISASSEMBLY
1) Secure the gearbox removed from vehicle in
vise using the ST.
ST 926200000 STAND
CAUTION:
Secure the gearbox assembly in a vise using
the ST as shown. Do not attempt to secure it
without this ST.
(1) Clamp
2) Remove the tie-rod end and lock nut from gear-
box.
STEERING GEARBOX [RHD MODEL]
PS-00051
PS-00052
PS-49
POWER ASSISTED SYSTEM (POWER STEERING)
3) Remove the clip on outside of boot using pliers,
and then slide the boot to tie-rod end side.
(1) Clip
4) Using flat tip screwdriver, remove the band from
boot.
NOTE:
Check the boot for crack, damage or deterioration.
Replace the boot with a new one if necessary.
(1) Band
5) Using the ST, loosen lock nut.
ST 926230000 SPANNER
(1) Lock nut
PS-00053
PS-00054
PS-00056