Subaru Impreza 2003 Service Manual page 2621

PARKING BRAKE ASSEMBLY (REAR DISC BRAKE)
B: INSTALLATION
CAUTION:
Be sure the lining surface is free from oil and
grease contamination.
1) Apply brake grease to the following places.
Brake grease:
Brake Grease (Part No. 003602002)
• Six contact surfaces of shoe rim and back plate
packing
• Contact surface of shoe wave and anchor pin
• Contact surface of lever and strut
• Contact surface of shoe wave and adjuster as-
sembly
• Contact surface of shoe wave and strut
• Contact surface of lever and shoe wave
2) Insert the primary side brake shoe into anchor
pin groove.
3) Secure the brake shoe with shoe hold-down pin
and cup.
4) Install the plate to anchor pin, and then assem-
ble the primary return spring to anchor pin.
(1)
(4)
(5)
(1) Primary return spring
(2) Anchor pin
(3) Plate
(4) Primary shoe
(5) Shoe hold-down pin & cup
5) Install the parking brake cable to parking brake
lever.
6) Assemble the strut and adjuster, and then se-
cure the secondary side brake shoe with shoe hold-
down pin & cup.
NOTE:
• Install the strut spring of both right and left
wheels facing vehicle front.
• Install the adjuster assembly with screw on left
side.
7) Install the secondary return spring and adjusting
spring.
(2)
(3)
PB-00039
8) Adjust the parking brakes. <Ref. to PB-10, AD-
JUSTMENT, Parking Brake Assembly (Rear Disc
Brake).>
9) Drive the vehicle for parking brake lining "break-
in".
PB-9
(1) Left
(1)
(2)
(8)
(1) Lever
(2) Secondary brake shoe
(3) Strut spring
(4) Strut
(5) Return spring
(6) Adjuster
(7) Shoe hold-down cup
(8) Adjusting spring
(1) Drive the vehicle at about 35 km/h (22
MPH).
(2) With the parking brake release button
pushed in, pull the parking brake lever gently.
(3) Drive the vehicle for about 200 meter (0.12
mile) in this condition.
(4) Wait 5 to 10 minutes for the parking brake to
cool down. Repeat this procedure once more.
(5) After breaking-in, re-adjust the parking
brakes.
PARKING BRAKE
PB-00016
(4)
(3)
(5)
(7)
(6)
PB-00017