Subaru Impreza 2003 Service Manual page 2584

BRAKE
D: ASSEMBLY
1) Clean all parts in brake fluid. Check and replace
the faulty parts.
• Cup and boot for damage or fatigue
• Cylinder, piston and spring or damage or rust for-
mation
2) Assemble in the reverse order of disassembly.
(1) When installing the cup, use ST, apply
brake fluid to the frictional surface for smooth in-
stallation and pay attention to cup direction.
(2) STs are available in different sizes.
CAUTION:
When replacing the repair kit, make sure that
the sizes of cylinder and cup are same as those
which were replaced.
ST: ADAPTER
Applicable size
11/16"
CAUTION:
While assembling, be careful to prevent any
metal chip, dust or dirt from entering the wheel
cylinder.
(1) Cup
(2) Piston
REAR DRUM BRAKE ASSEMBLY
Part No.
925460000
(1)
ST
(2)
(1)
(2)
BR-00067
BR-52
3) Apply rubber grease to the boot inside as shown
in the figure.
CAUTION:
Never use brake grease.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
E: INSPECTION
1) If the deformation or wear of back plate, shoe,
etc. are notable, replace them.
BR-00068