BRAKE
3. 17 INCH TYPE
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift-up the vehicle, and then remove the rear
wheel.
4) Remove the clip.
(1) Clip
5) Remove the pad pins and cross spring.
(2)
(1) Cross spring
(2) Pad pin
6) Expand the pads and push piston back.
7) Remove the pad.
(1) Rear brake pad
REAR BRAKE PAD
(1)
BR-00313
(1)
BR-00311
(1)
BR-00312
B: INSTALLATION
1. 14 INCH TYPE
1) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to the frictional portion between pad
and pad clip.
2) Install the pad on support.
3) Install the caliper body on support.
Tightening torque:
37 N·m (3.8 kgf-m, 27.5 ft-lb)
NOTE:
If it is difficult to push the piston during pad replace-
ment, loosen air bleeder to facilitate work.
2. 15 INCH TYPE
1) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to frictional portion between pad and
pad inner shim.
2) Install the pads on caliper body.
3) Install the cross spring.
4) Install the pad pins on caliper body.
5) Install the M clip.
3. 17 INCH TYPE
1) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to frictional portion between pad and
pad inner shim.
2) Install the pads on caliper body.
3) Install the cross spring and pad pins.
4) Install the Clip.
BR-38