Subaru Impreza 2003 Service Manual page 2569

5. Rear Brake Pad
A: REMOVAL
1. 14 INCH TYPE
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift-up the vehicle, and then remove the rear
wheel.
4) Remove the lower caliper bolt.
5) Raise the caliper body upward and support it.
NOTE:
Do not disconnect the brake hose from caliper
body.
6) Remove the pad.
NOTE:
If the brake pad is difficult to remove, use the same
procedure as for front disc brake pad.
<Ref. to BR-25, REMOVAL, Front Brake Pad.>
REAR BRAKE PAD
2. 15 INCH TYPE
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift-up the vehicle, and then remove the rear
wheel.
4) Remove the M clip.
BR-00123
5) Remove the two pad pins.
6) Remove the cross spring.
7) Expand the pads and push piston back.
8) Remove the pad and shim.
BR-00032
BR-37
(1) M clip
(2) Caliper
(2)
(1) Cross spring
(2) Pad pin
(1)
(1) Brake pad
BRAKE
(1)
(2)
BR-00310
(1)
BR-00311
BR-00312