Subaru Impreza 2003 Service Manual page 2582

BRAKE
10.Rear Drum Brake Assembly
A: REMOVAL
CAUTION:
Do not allow brake fluid to come in contact with
vehicle body; wash away with water and wipe
off completely if spilled.
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift-up the vehicle, and then remove the wheels.
4) Release the parking brake.
5) Remove the brake drum from brake assembly.
<Ref. to BR-49, REMOVAL, Rear Drum Brake
Drum.>
6) Remove the brake shoe. <Ref. to BR-47, RE-
MOVAL, Rear Drum Brake Shoe.>
7) Disconnect the brake hose. <Ref. to BR-65,
REAR BRAKE HOSE (DRUM BRAKE), REMOV-
AL, Brake Hose.>
8) Remove the hub. <Ref. to DS-24, REMOVAL,
Rear Axle.>
9) Disconnect the ABS wheel speed sensor from
back plate.
10) Remove the brake assembly.
11) Remove the bolts installing wheel cylinder on
back plate, and remove it.
REAR DRUM BRAKE ASSEMBLY
BR-00060
BR-00061
BR-50
B: INSTALLATION
1) Clean the back plate and wheel cylinder.
2) Install the wheel cylinder on back plate, and
tighten bolts.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
3) Apply grease to the portions indicated by arrows
in the figure.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
003602001)
4) Install the brake assembly on housing, and tight-
en the bolts to install back plate.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
5) Install the hub. <Ref. to DS-27, INSTALLATION,
Rear Axle.>
BR-00061
BR-00053
BR-00060