Subaru Impreza 2003 Service Manual page 2605

19.Stop Light Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the stop light switch connector.
3) Loosen nuts, and unscrew stop light switch to re-
move.
(1) Stop light switch
B: INSTALLATION
1) Screw the stop light switch onto a bracket and
secure it temporarily with a nut.
2) Adjust the stop light switch position, and then
tighten the nut.
<Ref. to BR-74, ADJUSTMENT, Stop Light
Switch.>
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
STOP LIGHT SWITCH
(1)
BR-00107
T
BR-00108
BR-73
C: INSPECTION
1) If the stop light switch does not operate properly
(or if it does not stop at the specified position), re-
place with a new one.
Specified position: L
2 mm (0.079 in)
L
2) Measure the clearance between threaded end of
stop light switch and stopper.
CAUTION:
Be careful not to rotate stop light switch.
Stop light switch clearance: A
0.3 mm (0.012 in)
(1) Stop light switch
(2) Stopper
(3) Brake pedal
3) If it is not within specified value, adjust it by ad-
justing position of stop light switch.
CAUTION:
Be careful not to rotate the stop light switch.
BRAKE
BR-00109
(1)
A
(2)
(3)
BR-00110