Subaru Impreza 2003 Service Manual page 2603

4. LHD AT MODEL
1) Remove the brake switch.
2) Unbolt, and then remove the brake pedal.
3) Remove the bushing, spacer and spring.
(1) Plug
(2) Stopper
(3) Brake pedal
(4) Brake pedal spring
4) Remove the brake pedal pad.
5. RHD AT MODEL
Do not disassemble the brake pedal because it has
non-disassemble structure.
6. RHD MT MODEL
Do not disassemble the brake pedal because it has
non-disassemble structure.
BRAKE PEDAL
D: ASSEMBLY
1) Attach the stop light switch, etc. to pedal bracket
temporarily.
2) Clean the inside of bores of clutch pedal and
brake pedal, apply grease, and set the bushings
into bores.
3) Align bores of the pedal bracket, clutch pedal
and brake pedal, attach the brake pedal return
spring and clutch pedal effort reducing spring
(model with hill holder), and then install the pedal
bolt.
NOTE:
Clean up the inside of bushings and apply grease
before installing spacer.
BR-00100
Tightening torque:
T: 29 N·m (3.0 kgf-m, 21.7 ft-lb)
BR-00101
4) Adjust the stop light switch position after install-
ing the brake pedal to vehicle.
BR-71
T
BRAKE
BR-00102