Alcatel-Lucent 7302 Information Manual page 680

NTP 116 — Replace an G-241W-P or I-241W-T indoor ONT
10 Connect the SC/APC fiber optic cable (DLP 125).
11 Connect the power cable to the power connector.
12 Power up the unit by using the on/off power switch.
13 If used, enable the Wi-Fi service using the Web GUI.
14 If used, configure the SLID (DLP 6).
15 Verify the ONT LEDs, voltage status, and optical signal levels (DLP 127).
16 Activate and test the services (DLP 128).
17 STOP. This procedure is complete.
NTP 116-4 November 2013
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT; see the operations and
maintenance documentation for the OLT for more information.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide