Ntp 121-5: Molex 8-Pin Connector - Alcatel-Lucent 7302 Information Manual

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

NTP 121 — Install an I-010G-B, I-020G-M, or I-040G-B indoor ONT

Connect the power cable with an 8-pin Molex connector to the ONT unit.

Figure NTP 121-4: Power connector pin configuration for I-010G-B, I-020G-M, and

Power up the ONT unit by using the ON/OFF power switch.

November 2013

Warning — To avoid the possibility of damage to the pins on the power

cable connector, carefully align the pins on the connector on the cable

with the pin holes in the power connector on the ONT before making the

connection. The pin hole configuration in the power connector on the

ONT is shown in Figure

Molex connector is shown in Figure

Note — When the I-040G-B ONT is used with the Delta DUPS-1215 4.5Ah

UPS at ac line voltages above 200 V ac (either 50 or 60Hz), then the dc

power cable must be equipped with an external clamp-on ferrite

[Fair-Rite 0431167281 (1AB 09397 0026)]. The ferrite must be installed

closer to the UPS than the ONT on the dc power cable.

I-040G-B indoor ONTs

Figure NTP 121-5: Molex 8-pin connector

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

while the pin arrangement on the

ONT Product Information Guide

3FE 55873 AAAA TCZZA