Alcatel-Lucent 7302 Information Manual page 464

6 — ONT management using an ONT interface
LED
EQPT
PON
IPTV
RFTV
POTS
MGMT
NTWK
DATA
VID
FAIL
BTRY
MOCA
PWR_LED
ALM_LED
WAN_LED
This section shows you how to check the current and persistent state of LEDs.
Prerequisites
The prerequisites are:
•
The user access level of the ONT is read-write.
•
The steps to access the interface are completed.
•
•
Procedures using HTTP interface
The following procedure provides the steps to check the status of the ONT LEDs
using the HTTP interface.
6-32 November 2013
Description
Battery power is available.
The PON is communicating with the ONT.
The IPTV service is provisioned.
The RF video is provisioned.
A phone is off-hook.
Communication is established between the P-OLT and ONT through OMCI.
The 1490 nm data path is available.
The data (Ethernet or MoCA) link is active, or if the data link is not active or
not provisioned.
The video signal is above or below acceptable level or not provisioned.
The equipment is 100% operational, or the equipment has failure, or is not
ranged or synchronized.
The status of the battery
The activity on the MoCA link
There is power to the ONT
The operational state of the ONT
The ONT is connected properly to the PON.
Note —
Table 6-8 lists all possible LEDs on an ONT. For a list of
LEDs specific to a particular ONT, see the unit data sheet for that
ONT.
See Procedure 6-1 for HTTP interface using the first Ethernet port.
See Procedure 6-4 for CLI interface using the first Ethernet port.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Table 6-8 ONT LEDs
Edition 01
ONT Product Information Guide
3FE 55873 AAAA TCZZA